Back onto the headlight bezel thing for a minute.
The new outer bulb brackets are the same size as the old brackets, so that’s not the problem. It looks like the bulbs are just sitting off center in the bucket. Kicking that can on down the road for another day.
There is this thing that also needs attention.
Which looked like this after a little while
and is now torn down even further… No spark. New points, condenser, coil, and a fresh fuse.
Anyway, back to the other lady.
I replaced the heat exchanger hoses (which were held on with black household caulk) and the air intake hose (Amazon link). All shiny, but man that original cardboard covered hose is so much sturdier. I will likely end up having to put that back on unless I can find one that isn’t made of aluminum foil.
Every couple of days, when I lift up the trunk lid, the gas tank has overflowed here around the fuel sending unit. “New gas tank” he said. Sometimes it’s a little puddle and sometimes it has flowed all down the sides and into the spare tire well.
I tried to measure the resistance of the fuel sending unit with a multimeter, to figure out why the gas gauge stopped working, but either I wasn’t doing it right, or it’s dead. But either way, new gasket and mounting screws with little nylon washer things to snug down in the mounting holes better (Amazon link).
Seeing as how the spare tire well is always wet with water (and hopefully no longer with gas) it’s pretty rusty down in there. I thought that would be a good, out of sight, place to do some painting.
I got some nylon cup brushes (Amazon link) and went after it in the wrong order (the softest one didn’t remove much, so I stepped up and removed a little more, then stepped up to the stiffest one and removed a little more).
Wiped it all down with acetone and started spraying. First with rust converter, then primer.
You can see that the factory Zenith Blue paint is actually blue, when you put a gray primer up against it.
There are some weird angles in there and I had a couple of runs. I’m a well-qualified rattle can spray painter, but this Krylon Fusion 2 in 1 really runs wayyy too easily.
I pulled the inspection panel covers off and gave them the business as well.
And then a couple of quick coats of Matte Vintage Blue paint, Krylon Fusion. Oh, and I did wipe off that body tag and the gas tank with acetone after each coat to get rid of the over-spray.
Note: This color is apparently no longer available from Krylon. That happens SO OFTEN – I find something I like and it immediately is removed from the marketplace. I only bought one can and am now hitting every Ace Hardware in town trying to buy up all remaining stock. They are completely gone from Lowes…
Why are there flies all over my truck?
Anyway, with it all back together, it looks pretty sharp. The color match isn’t too bad for some random rattle can from Lowes.
I don’t think I would paint the outside of the car with it, but if I’m doing body work and removing rust, it would definitely be a better alternative to leaving it in primer for who knows how long.
Seriously, there are flies all over…
