Back to that driver’s side rear wheel, I made a couple more attempts at getting the axle nut loose. For a start, I bought a Bernzomatic MAP gas hand torch kit (Amazon link)…
I heated the axle nut until it was smoking, then jumped up and down on it with my old faithful 17″ long Goodwrench 1/2″ drive breaker bar with an 18″ cheater pipe.
Broken breaker bar… OK, fine. I went to Harbor Freight and bought the biggest 1/2″ drive breaker bar they had, a 25″ Icon brand (Harbor Freight link).
That comfort grip TPR handle wasn’t very comfortable. Also, it was too large to fit inside the cheater pipe. That would have left me at 25″ instead of the 35″ I had with the cheater pipe.
So, looking at the business end of each breaker bar, they both had a similar allen key bolt holding the drive in. Swapped those out and was back in business with my old Goodwrench breaker bar and cheater pipe.
But, still no luck. Several cycles of heating and torquing later, the axle nut was still frozen solid.
With the car in gear, the parking brake on, and a jack stand jammed up under the front of the wheel, I still managed to dig a rut by spinning the wheel…
It was also now sitting on top of that jack stand wheel chock, so I had to put it in neutral, release the parking brake, and push the car back a few inches to be able to get the jack stand out.
Giving up for the day (again).
